Oregon plumber installer license prep class instal the new for android

Previously, if an installation required more than 24” of piping, the job would have had to be done by a licensed journeyman plumber.

Notably, this includes heat pump water heaters, which commonly have connections on the side of the unit that may require longer material lengths than conventional tank water heaters to make connections. This is an increase from the previous limit of 24”, and allows for easier connections to more types of water heaters. Starting October 1, 2020, anyone with an Oregon Residential Water Heater Installer (WHI) license will be able to install up to 96” of material length for each of the hot and cold water connections to a water heater. Unlisted water heaters shall be permitted in accordance with Section 50 5.3.2.An amendment to the scope of the Residential Water Heater Installer (WHI) license will allow greater flexibility and more types of water heaters to be installed in Oregon. Listed appliances shall be installed in accordance with the manufacturer's installation instructions.

A list of accepted water heater appliance standards is referenced in Table 501.1(1). No water heater shall be hereinafter installed that does not comply with the manufacturer's installation instructions and the type and model of each size thereof approved by the State Plumbing Board.

The minimum capacity for storage water heaters shall be in accordance with the first-hour rating listed in Table 501.1(2). The regulations of this chapter shall govern the construction, location, and installation of fuel-burning instantaneous and other types of water heaters heating potable water.

Oregon plumber installer license prep class instal the new for android